Why People Don't Care About 10kg Front Loader > 자유게시판

Why Buy a 10kg Front Loader?

The 10kg front-loader is perfect for large loads of laundry with 13 wash programs including handwash and plenty of space for big wash cycles. With advanced technology and smart features, it's a perfect partner for home laundry.

Front loaders are usually slower to clean they are not offered in larger capacities and are susceptible to mould or mildew. However, they are more efficient in water and energy than top loaders.

Energy

The major energy expense of a front loader of cheapest 10kg washing machines is electricity to heat water to operating temperature and also to run the motor. These costs can be offset by lower energy consumption compared to top-loaders. This includes less power required during the spin cycle and agitation cycles, as well as using less water. Some machines offer a low-water cycle that uses less water than the cotton cycle. This can save water and energy.

In general, front-loading washers consume less soap than top-loaders. The drum's tumbling reduces foamy suds and decreases overflows, without affecting the cleaning action. The door seals and bellows on top-loaders are more susceptible to wear. The mechanical agitator in a top-loader can also cause significant wear to clothing fabrics. It drags and falls clothes continuously, pushing them against one another. This abrasion can be measured by the amount fabric that is left on a clothes dryer screen for lint, since lint is primarily composed of stray fibers that are separated from clothing during washing and drying. To reduce this, many top-loaders are constructed to operate at a slower rate and may also have a "freshening" cycle to periodically clean the mechanical bellows and gears.

Water

Top-load washers need an agitator or impeller to force water and detergent through clothes, which creates mechanical wear and abrasion. By contrast, front-loaders use paddles that gently lift and lower clothing inside a spinning drum for cleaning, which reduces wear. The amount of lint that is in the dryer lint filters can be used to estimate the rate of wear. Lint is largely made of threads that are removed from clothing while washing and drying.

Front-loading machines are less likely to leak since they have lower levels of water than top-loaders. True front-loaders may require a bellows seal or seal to prevent water from flowing out of the open door during operation, but they do not typically require maintenance as regularly as their counterparts on top-loaders.

Additionally, laundry front-loaders can operate with cold water or hot, and many do so without the need for a heating source, which makes them more energy efficient than most top-load machines. This efficiency can lower operating costs for the same laundry load in places where water, laundry energy, and detergents are expensive.